Chapter 19 - Flight / Maintenance - Oxy Heli OXY 3 Instruction Manual

Before Flight.
Now complete the setup of your FBL system. In the Accessories Bag you will find an Oxy 3 Swash Plate Leveler.
This Tool is designed to fit under the Swash Plate without disassembly any parts. This simple tool will both level the swash and give
the Zero Pitch Position.
Starting gyro gain: The Oxy 3 was designed around famous FBL Systems (IKON / Brain / mini V-Bar), and we suggest you start with
the following standard set up and adjust after test flying.
Cyclic Set Up:
Use suggested settings for 450 Helicopters and adjust after test flights.
See our table on page 15 for RPM and Pitch Settings. Cyclic Max pitch should be +/- 10.5 deg.
Tail Set Up:
Use the suggested settings for 450 Helicopters BUT start with a lower Tail Gain
IKON / Brain = 20%
Mini V-Bar = 250 Heli suggested gain.
Main Grip assembly.
2 x TCEM2X14
Shoulder Button Cap
Screw M2X14
Note: The Oxy Main Grips have a 5.5mm root cavity
in order to work with any standard 245 / 255 main
blade root.
Use main blade shims if necessary.
Shims are usually supplied with the main blades.
Battery Assembly.
Page 33
ZHM-285 - ZEAL
Blades 285mm
(1SET)
2 x OXY0180
OXY3-ZEAL
Blade Shim
2 x SLNM2
Self Lock Nut M2
2 x OXY0098
Battery Oring
Important Note: Use both double sided Hook
and Loop Velcro and the included battery
straps to fully secure the battery pack.
Chapter 19, Flight/ Maintenance
Tail Grip assembly.
OXY0101
Tail Blade 50mm
Oxy tail blade dimension note: In order to assure
the best performance Oxy made a custom tail
blade with a 3.5mm root. If you use different tail
blades with a 2.5mm root you must use shims (not
included).
Information about 47 and 50mm tail blades: In the
kit we include two sets of tail blades - the 47mm are
designed for high head speed, the 50mm are designed
for low head speed. We recommends using 47mm
when head speed is higher than 4000rpm.
2 x OXY0076
Shoulder Button
Cap Screw M2x10
Important Note:
Add Loctite onto the
Tail Grip screw thread
to avoid getting Loctite
on the Tail Blades.