Table of Contents
Advertisement
Main Rotor Assembly
( Box 3/ Bag 17 )
loctite 468
2 x MR104_ZZC -
4X10X4 Radial Bearing
Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly.
TCEM2.5X6-
M2.5X6 Hex Cap Screw
loctite 243
OXY0332-M2.5 Washer
page 24
4.2mm
F4-10G - 4X10X4
Thrust Bearing
loctite 468
Shim 4x6x0.1
Step Faced to Main Grip
OXY0680-Damperner Spacer
OXY0361-Shim 4x6x0.1
A
OXY0325-
Damperner Bushing
add silicone grease
4mm
Important Note:
This part, for tuning reasons,
comes factory pre assembled
with grease and loctite. It is
ready to use.
OXY0324 - Center Hub
OXY0339-Spindle Shaft
OR6x1.5-Oring
ID6x1.5 Shore 80-90
Chapter 11: Main Rotor Assembly
OXY0666 -
Threaded Rod M2X10
OXY0716 -
PL linkage Ball
OXY0012 -
DFC Arm Spacer
OXY0734-DFC Arm
Ref 35mm
Fine Adjust Shims:
In order to give fine adjustment options,
the extra Hardware Bag contains extra
Shims 4x6x0.1. Start assembly
with one (each side)pre installed shim.
If the Main Grips have
sideway play, add shims as required.
Each Grips must have the same number
of shims. If you add one shim on the left
side, you need to also add one shim on
the right side
2 x MR52-W2-
2X5X2 Radial Bearing
Advertisement
Table of Contents
