Ariens Sno-Thro 926 Service Manual page 42

RUNNERS
CAUTION: Adjust auger/impeller housing
height to clear gravel or crushed rock
surfaces.
Runners should be adjusted as conditions require. Raising or lowering runners controls distance scraper blade is
held above surface being cleared.
When operating machine on gravel surface, lower runners so the housing will not pick up gravel. On concrete,
blacktopped or packed down snow surfaces, raise runners so that scraper blade scrapes clean.
Position unit on a flat level surface. Adjust runners by inserting a spacer of desired thickness under center of
scraper blade, loosen hardware, slide runners to flat surface and retighten hardware.
NOTE: Above method keeps housing level by adjusting runners equally. Uneven runners make machine difficult to
steer and results in uneven clearing.
GB - 44