Ariens Sno-Thro 926 Service Manual page 26

6
1. Engine Sheave
2. Attachment Drive Belt
3. Belt Finger
4. Attachment Belt Idler
Figure 32
Check Attachment Brake
When the clutch lever is disengaged, the brake
must contact attachment belt.
When the clutch lever is engaged, the brake must
be more than 1/16 in. (1.6 mm) away from the
belt (Figure 33).
1
2
Minimum of 1/16 in.
(1.6 mm)
1. Drive Belt
2. Brake Shoe and Pad
Figure 33
1. Repeat steps 1 – until spring extension and
brake clearance are within specified range.
1
2
3
3
4
5
5. Attachment Pulley
6. Attachment Idler
Adjustment Nut
OS7195
OS7200
2. Check belt finger clearance (Figure 36).
With clutch lever engaged, belt finger on the side
opposite the belt idler should be less than 1/8 in.
(3 mm) from belt, but not touching the belt. Adjust
belt finger as necessary.
3. Replace bottom cover.
4. Replace belt cover.
TRACTION DRIVE CLUTCH ADJUSTMENT
If drive slips, adjust traction clutch to compensate for
friction disc wear.
To adjust traction clutch:
1. Place speed selector in fastest forward speed.
2. Place unit in service position.
3. Measure the length of the traction drive clutch
spring at the top of the traction cable. See Figure
34.
4. Engage and hold the traction drive clutch lever
and measure the spring again. The spring should
be 1/2 -11/16 in. (12.7-17.5 mm) longer when the
lever is engaged.
1. Traction Drive Clutch Spring
2. Jam Nut
3. Adjuster Body
GB - 28
1
2
3
1/2 -11/16 in.
(12.7-17.5 mm)
Figure 34
OS7205
OS7210