•
Place the jack near the wheel to be
changed as illustrated. Make sure
that the head of the jack is correctly
inserted in one of the slots 1 or 2 under
the longitudinal member.
WARNING!
•
Never position yourself under a jacked
vehicle.
•
Jack wrong positioning can cause
vehicle accidental fall, with
consequent severe risk for operator's
safety and damages to vehicle body.
•
Never use the jack to carry out
maintenance or repairs under the
vehicle.
•
Insert the lever in the jack.
•
Turn clockwise the lever of the
jack until the wheel is raised a few
centimetres off the ground.
In an Emergency
•
Completely unscrew the five bolts and
remove the wheel.
•
Make sure that the contact surfaces
between spare wheel and hub are
clean and free of impurities.
•
Fit the spare wheel with the valve stem
side out and secure it with the five
bolts previously removed, without
tightening them.
•
Remove from the compressor case the
inflation hose and the cable with a plug
for the power outlet.
•
Unscrew the valve cap of the spare
wheel and screw the fitting of the
inflation hose onto the valve.
•
Insert the plug inside one of the
available power outlets fitted in the
boot or passenger compartment.
•
Set the ignition device in ON position.
•
Turn the compressor on by pressing the
switch.
•
Stop the compressor pressing switch
again, when the pressure indicated by
the gauge reaches the recommended
6
279