Maserati GranTurismo Owner's Manual page 250

Driving and Driver Assistance Systems
ALM system remembers the condition it
was in before turning off the vehicle
Refer to "Functions of Controls Menu on
MIA" in section "Dashboard Instruments
and Controls" for further information.
NOTE:
5
In case of wet road or raining conditions
the function could be disabled by the
system in order to minimize the risks.
Active Blind Spot Assist (ABSA)
Intervention
When the system is enabled pushing the
button at the end of the left multifunction
lever and the driver intends to change
lane, using or not the turning light, an
active steering manoeuvre will be
performed if another vehicle is detected
in the Blind Spot detection zones (see
"Blind Spot Assist - BSA" in this section
for further information).
248
Emergency Lane Keeping (ELK)
Intervention
WARNING!
In special cases like vehicle oncoming,
vehicle overtaking, newjerseys or
guardrails, Active Lane Management
(ALM) may make an unexpected
steering torque application. Lack of
attention may lead to serious injury or
death.
Speed Range of Use
Speed km/h (mph)
Minimum 60 (37)
Engaged/activated 60 (37)
Maximum 180 (112)
Customised Settings
ALM is configurable by the customer
in order to maximize its efficiency
based on the driver driving style and his
expectation of the system, reducing at
the same time the possible invasiveness.
Entering "Settings" menu of the "Vehicle"
page on MIA display the driver can see
the current setting beside the "Active
Lane Management" soft-key.
Touching "Active Lane Management"
soft-key to enter the setting page.
The system can be set to "Vibration
only", "Steering Assist only" and
"Vibration + Steering Assist".
lane Warning can be set to "Early"
(default mode), "Medium" and "Late".
Vibration Strength can be set to "Low"
(default mode), "Medium" and "High".
Steering Assist Strength can be set to
"Low" (default mode), "Medium" and
"High".
Meanings of Settings
"Vibration and Steering Assist": the
system will apply steering torque when
lane departure is detected showing
at the same time the proper cluster
indication, adding to this steering
vibration when the departure is very
imminent.
When "Vibration and Steering Assist" is
selected and of course ALM is enabled
then two following menu will be used by
the system.
• "ALM Lane Warning": it tunes the
distance to the lane boundary
interested where the system will start
to apply steering torque.
• "ALM Vibration and Steering Assist
Strength": it tunes the vibration,
steering torque and speed value
increasing or decreasing it to have
a stronger or weaker trajectory
correction/deviation.