The flat head angle grinders, when fitted with orig- f) Threaded mounting of accessories must inal Metabo accessories, are suitable for grinding, match the grinder spindle thread. For accesso- sanding, cutting-off and wire brushing metal,...
Page 6
ENGLISH where the cutting accessory may contact d) Use special care when working around hidden wiring or its own cord. Cutting accessory corners, sharp edges etc. Avoid bouncing and contacting a "live" wire may make exposed metal snagging the accessory. Corners, sharp edges or parts of the power tool "live"...
Page 7
ENGLISH en occur. Investigate and take corrective action to accessory must match the thread on the spindle. eliminate the cause of the wheel jam. See page 3 and chapter 14. Technical Specifica- tions for more information on the spindle length and d) Do not restart the cutting operation in the thread.
8 Sliding on/off switch * packs. If necessary, consult your freight forwarder. 9 Handle Certified packaging is available from Metabo. 10 Switch-on lock * Only send the battery pack if the housing is intact 11 Trigger * and no fluid is leaking.
ENGLISH en If performance diminishes, recharge the battery - Fit the support flange (3) on the spindle. The pack. flange should not turn on the spindle when prop- erly attached. The ideal storage temperature is between 10°C and - Place the grinding wheel on the support flange (3). 30°C.
Press down the machine evenly on the surface and move back and forth so that the surface of the work- piece does not become too hot. Only use original Metabo battery packs and Metabo Roughing: position the machine at an angle of 30° - accessories.
Repairs to electrical tools must be carried out tolerances (in compliance with the relevant valid by qualified electricians ONLY! standards). If you have Metabo electrical tools that require Electromagnetic disturbances: repairs, please contact your Metabo service centre. In individual cases, the speed may fluctuate tempo- For addresses see www.metabo.com.