Table of Contents
Advertisement
A wet cloth may be used to clean the indoor unit if it is
very dirty.
Never use a damp cloth on the remote controller.
Do not use a chemically-treted duster for wiping or leave
such material on the unit for long.
it may damage or fade the surface of the unit.
Do
not
use
benzine,
solvents for cleaning.
These may cause the plastic surface to crack or deform.
Maintenance after a long stop period
(eg. at the beginning of the season)
Check and remove everything that might be blocking inlet
and outlet vents of indoor units and outdoor units.
Clean air filters and casings of indoor units.
Refer to "Cleaning the air filter" for details on how to
proceed and make sure to install cleaned air filters back in
the same position.
Turn on the power at least 12 hours before operating the
unit in order to ensure smoother operation. As soon as he
power is turned on, the remote controller displays appear.
Maintenance before a long stop period
(eg. at the end of the season)
Let the indoor units run in fan only operation for about half
a day in order to dry the interior of the units.
Clean
air
filters
and
Cleaning the air filter" for details on how to proceed and
make sure to install cleaned air filters back in the same
position.
■
Cleaning the air filter
The air filter can prevent the dust or other particulate from
going inside. In case of blockage of the filter, the working
efficiency of the air conditioner may greatly decrease.
Therefore, the filter must be cleaned once two weeks
during long time usage.
If the air conditioner is installed in a dust place, clean the
the air filter frequent.
If the accumulated dust is too heavy to be cleaned, please
replace the filter with a new one(replaceable air filter is an
optional fitting).
1
3.2-10.5KW
•
Open the air intake with the screwdriver or something like
that .(Refer to Fig.6-1)
•
Take out the air filter.(Refer to Fig.6-2)
•
Clean the air cleaning filter with water or vacuum cleaer,then
dry it in cool place.
•
Re-install the air filter in the reverse order of Fig.6-2.
2
14-16KW
•
Directly pull out the air filter from air inlet as indicated in
Fig.6-3.
•
Clean the air cleaning filter with water or vacuum cleaner,
then dry it in cool place.
•
Re-install the air filter in the reverse order of Fig.6-3.
owner's manual
7
thinner,
polishing
powder,
or
casings
of
indoor
units.
Refer
•
The air-in side should face up when using vacuum cleaner.
•
The air-in side should face down when using water.
similar
Do not dry out the air filter under direct sunshine or with fire.
to
"
7.
FOLLOWING SYMPTOMS ARE NOT AIR
CONDITIONER TROUBLES
Symptom 1: The system does not operate
■
The air conditioner does not start immediately after the ON/OFF
button on the romote controller is pressed.
If the operation lamp lights, the system is in normal condition.To
prevent
overloading
conditioner starts 3 minutes after it is turned ON.
■
If the operation lamp and the "PRE-DEF indicator(cooling and
heating type) or fan only indicator(cooling only type)" light, it
means you choose the heating model, When just starting, if the
compressor has not started, the indoor unit appears "anti cold
wind" protection because of its overlow outlet temperature.
NOTE
CAUTION
of
the
compressor
motor,
the
air
Advertisement
Chapters
Table of Contents
