Page 1
RLTGM25CS TRIMMER OPERATOR’S MANUAL (Original Instructions) Important! It is essential you read the instructions in this manual before starting and operating this machine. Subject to technical modifications.
English (Original Instructions) GENERAL SAFETY WARNINGS Dangerous Environments. To avoid falling, do not use the product in damp or wet locations. Controlling Product. During carburetor WARNING adjustments the cutting attachment may spin. Read and understand all instructions. Failure to Therefore, you should wear protective equipment follow all instructions may result in serious personal and observe all safety instructions when adjusting...
Page 3
English (Original Instructions) SYMBOLS The following symbols are located on labels on the attachment shaft. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. SYMBOL NAME DESIGNATION/EXPLANATION Safety Alert Precautions that involve your safety.
English (Original Instructions) SPECIFICATIONS 5. Front handle 6. Safety guard Weight without fuel 7. Trimmer line 3.56 Kg and trimmer head 8. Trimmer head Weight without fuel FIGURE 2 3.86 Kg with trimmer head 5. Front handle 9. Securing bolts Fuel tank volume 620 cm 10.
English (Original Instructions) Loosen the knob by turning it counterclockwise. Replace the line trimmer head cover, aligning latches Push the button while pulling out the attachment. with openings in the line trimmer head. Press cover and line trimmer head together until both latches snap ATTACHING THE FRONT HANDLE (FIG.
Page 6
English (Original Instructions) Do not use any type of pre-mixed petrol / oil from fuel STARTING THE PRODUCT (FIG. 4-5) service stations, this includes the pre-mixed petrol / oil Starting the product differs depending on whether the intended for use in mopeds, motorcycles, etc. engine is cold or warm.
English (Original Instructions) Trim grass and weeds in a left-to-right motion with the WARNING line parallel to the ground. Do not at any time let brake fluids, petrol, petroleum- TO ADVANCE THE CUTTING LINE based products, penetrating lubricants, etc., come Follow these steps to advance the cutting line.
English (Original Instructions) REPLACING THE SPARK PLUG (FIG. 10) This engine uses a Champion RCJ6Y or NGK BPMR7A spark plug. Use an exact replacement and replace annually. Follow these steps to replace the spark plug. Remove the spark plug boot (item 23). ...
English (Original Instructions) TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE SOLUTION 1. Switch set to the O (OFF) position. 1. Set switch to the I (ON) position. 2. No spark. 2. Remove the spark plug. Reattach the spark plug cap and lay the spark plug on the metal cylinder. Pull the starter cord and watch for a spark at the spark plug tip.
Page 10
FOR SPECIAL, INCIDENTAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES. OUR MAXIMUM LIABILITY SHALL NOT EXCEED THE ACTUAL PURCHASE PRICE PAID BY YOU FOR THE PRODUCT. This warranty is applicable only in the European Union, Australia, and New Zealand. Outside these areas, please contact your authorised Ryobi dealer to determine if another warranty applies.
Page 11
Marlow, Bucks Building B, Rosehill Industrial Estate, SL7 1TB - United Kingdom 3 Shirley Street, Rosehill NSW 2142 RYOBI TECHNOLOGIES (UK) LIMITED Australia Medina House, Field House Lane, Tel: (02) 8892 1800 or 1300 361 505 Marlow, Bucks Fax: 1800 807 993...
Need help?
Do you have a question about the RLTGM25CS and is the answer not in the manual?
Questions and answers