Page 1
RLT430CES 30cc 4 Stroke Petrol Line Trimmer OPERATOR’S MANUAL WARNING: It is essential that you read the instructions in this manual before operating this machine. RLT430CES manual(TTIA).indd A1 RLT430CES manual(TTIA).indd A1 09-9-23 09-9-23 5:18 5:18...
DO NOT SMOKE when refuelling. ■ Stop the engine and allow it to cool down before refuelling or storing the unit. ■ Allow the engine to cool; empty the fuel tank and secure the RLT430CES manual(TTIA).indd Sec2:1 RLT430CES manual(TTIA).indd Sec2:1 09-9-23 09-9-23 5:18 5:18...
Page 3
10W-30 is recommended. On/Off Switch Switch = On to Run O = OFF to Stop Run position. START Start/Choke position. HALF Half choke position (For cold conditions. See troubleshooting). CHOKE RLT430CES manual(TTIA).indd Sec2:2 RLT430CES manual(TTIA).indd Sec2:2 09-9-23 09-9-23 5:18 5:18...
Page 4
If you do not understand the warnings and instructions in the SAVE THESE INSTRUCTIONS operator’s manual, do not use this product. Call Ryobi customer service for assistance. RLT430CES manual(TTIA).indd Sec2:3 RLT430CES manual(TTIA).indd Sec2:3...
35. Run position Rear handle..........1.24 m/s and 1.72 m/s Sound pressure level Fig.13 (in accordance with ISO22868)........94 dB (A) 36. Cover Sound power level 37. Latches (in accordance with ISO22868)........113 dB (A) RLT430CES manual(TTIA).indd Sec2:4 RLT430CES manual(TTIA).indd Sec2:4 09-9-23 09-9-23 5:18 5:18...
Page 6
■ Remove the clamp and bolts from the front handle. ■ If any parts are damaged or missing, please call Ryobi ■ Install the front handle onto the top side of the drive shaft customer service for assistance.
Push the knob in while pulling on line(s) to manually advance To add engine lubricant: the line. See Figure 6. NOTE: Pro Cut II™ line cannot be advanced. To replace the line, RLT430CES manual(TTIA).indd Sec2:6 RLT430CES manual(TTIA).indd Sec2:6 09-9-23 09-9-23 5:18...
To start a warm engine: ■ Reinstall the spool. For the RLT430CES curved line trimmer DO NOT squeeze the throttle trigger until the engine starts and attachment, the spool should be placed so “This side out runs.
Rotate the knob on the line trimmer head to wind the line. If from the cutting attachment turning at idle. using the RLT430CES curved shaft line trimmer attachment, the knob should be rotated clockwise. If using a straight shaft CLEANING AIR FILTER SCREEN attachment, the knob should be rotated counterclockwise.
See Adding/Checking Engine Lubricant in the Operation section of this manual. CALL US FIRST For any questions about operating or maintaining your product, call the Ryobi Help Line! ® Your product has been fully tested prior to shipment to ensure your complete satisfaction.
Page 11
PAID BY YOU FOR THE PRODUCT. This warranty is valid only in the European Union, Australia and New Zealand. Outside these areas, please contact your authorized Ryobi dealer to determine if another warranty applies. CE DECLARATION OF CONFORMITY We declare in sole responsibility that the product: - to which this manual applies, conforms to the basic health and...
Need help?
Do you have a question about the RLT430CES and is the answer not in the manual?
Questions and answers