Advertisement
• Protective Cover
Hook
The protective cover is to be attached over the connected I/O module
at the right end.
Align the hooks on the cover with the grooves of the module and slide it
straight until the hooks are latched.
When removing the cover, pull it out while squeezing the hooks inward.
■ HOW TO MOUNT THE MODULE ON DIN RAIL
Groove
Release the locking clamps and pull out straight the module.
• Removing an intermediate module
Caution !
1) Be careful not to hurt your hand by pointed edges of the internal
2) I/O modules cannot hold tightly on the DIN rail by themselves without
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
communication bus connector.
power/network module.
Secure them to the position if necessary by using DIN rail end plates.
R8-DCM16ALH
EM-9746 Rev.2
P. 2 / 5
Advertisement
