Midea MKG Series Technical & Service Manual page 38

13.2.2 Function summarize
Air filt er cleaning reminding function
Indoor unit address setting function
Remote control receiver function
1 Remote signal receiving function
There is the signal receiver for wireless remote controller on the KJR-29B.You can use the wireless remote controller
to control the air-conditioner through the wired controller when the system has been powered on.
Note: The wired controller will not receive the swing controlling instruction. For the indoor unit with swinging function, you can directly use the remote
controller to control swinging through the display panel of the indoor unit, or use the swing button on the wired remote controller to control the indoor unit
for swinging.
2 ON/OFF button
Press the ON/OFF button to control the indoor unit on and off state. When the unit is turned off, press the ON/OFF
button, the unit will be turned on and the operating icon lights up. When the unit is turned on, press the ON/OFF
button, the unit will be turned off and the operating icon lights off.
3 Mode button
Press the mode button to set the operating mode, after each button press the operation mode will circle as follow:
AUTO COOL
When the controller has been set to cool-only, then there is no HEAT mode.
4 Fan speed setting
Under COOL, HEAT and FAN modes, press the fan speed button can adjust the fan speed setting. After each fan
speed button press will circle as follow:
AUTO→LOW→MID→HIGH→AUTO
Under AUTO and DRY modes, the fan speed is not adjustable and the default fan speed is auto.
5 Temperature setting
Under AUTO, COOL, DRY, HEAT modes, press the Temp adjust Up/Down buttons to set the temperature, the
adjusting range is 17℃~30℃ (or 62℉~88℉). The setting temperature cannot be adjusted under FAN mode.
6 Timer on and Timer off setting
Press the timer/clock setting button, then enter into the timer on setting state, and the screen will display timer icon
and .
You can press Temperature setting buttons to adjust the time. When the time setting is less than 10 hours, each
press the Temp setting buttons will increase or decrease 0.5 hour. When the timer setting is more than 10 hours,
each press Temp setting buttons will increase or decrease 1 hour, the maximum timer setting is 24 hours. After finish
adjusting the time on setting, press the Silent/OK button or wait for 5 seconds to confirm and exit the time on setting.
Notes: If the wired controller has been set timer on/ off, press the ON/OFF button to turn on/ turn off the unit then the timer will be canceled
simultaneously.
7 Clock setting
Long press the timer/clock setting button for 3 seconds, and then enter into the clock setting state. The hour position
of the clock will flash, and can press Temp setting buttons to adjust the hour value.
After finish the hour setting, press left button or right button to switch to minute position setting, then the minute
position will flash, press Temp setting buttons to adjust the minute value. After finish the clock setting, press the
button or wait for 5seconds to confirm and exit the setting state.
AC Fan Coil Unit Two-pipe Wall-mounted Series
New function
Lock the wired controller
Silent mode
Follow me
DRY HEAT
ON and OFF the air-conditioner
Auto-restart function
Time ON and Time OFF setting
Setting the Operating mode, Temperature
Fan speed and Swing functions
FAN
- 37 -
Basic function
Cloc k setting