Preparation And Setup; Printing Preparation - Carima IMD Manual

PREPARATION AND SETUP

Preparation and
Setup

PRINTING PREPARATION

To start printing, you must first prepare the
materials. Materials include resin vat, resin, and build
plate.
Align the detached vat and fasten it to
the vat retention knob.
Pour the resin into the resin vat.
Fasten the plate to the build plate fixing base
and to the module with the fixing fin.
Scratching the FEP film with sharp scrapers
or cutters will tear and contaminate the
engine room due to leakage of resin.
* Build plate, vat, FEP film, etc. are accessories.
To purchase additional accessories, contact Carima.
IMD AGENCY MANUAL
sales@carima.com
02-3663-8877
Information on the use of resin
Use protective equipment when using resin.
Pour resin before printing and on inevitable
occasions, press the 'Pause' button and wait
for a complete stop before slowly pouring
the resin into the vat. Adding the resin during
output can cause bubbles and adversely affect
the print.
Information on the use of resin vat
The FEP film may tear or loosen during
output. In this case, replace it with a new
one to prevent resin leakage. It may get
scratched due to user carelessness or by
hardened outputs. Be aware, for it may
occur in short-term use.
Information on maintaining the
build plate
Clean the build plate by scraping it off
with a scraper or by wiping with alcohol.
Thoroughly wipe the resin off before using
a different resin.
Information on optical engine
The lifespan of the optical engine lamp is
20,000 hours. When it exceeds 20,000
hours, the brightness of the lamp may
decrease. Once it exceeds its usage time,
improve the quality of the output by
replacing it with a new lamp.
06
www.carima.com