Faq - Carima IMD Manual

MAINTENANCE

FAQ

Most asked questions while using Carima's printer.
Q.
The engine won't turn on.
Turn off the power and then turn down the
A.
switch located at the back. Wait for at least
1-3 minutes and then turn it on again. If the
power does not turn on, contact Carima.
Q.
The printer is not printing.
Check if the engine light is on and set the
A.
exposure time again. If it doesn't print,
contact Carima.
Q.
If the output falls while printing,
what do I do?
A.
Stop the operation and turn off the
engine, take out the vat and filter out the
residue. Take caution when taking it out, for the
resin on the build plate may fall on the engine.
Q.
How do I clean the vat?
Check for residue in the vat. To remove the leftover residue, filter out the resin in the vat separately
A.
through the funnel and the sieve net. Lightly wipe the resin inside the vat with tissue paper and alcohol.
Make sure that the resin and alcohol do not get into the vat's gap.
* You can also use the 'Exposure light for cleaning' to remove residue.
Q.
How do I manage the printer when it is not in use?
The resin vat of an unused printer should be emptied and cleaned with alcohol.
A.
Unplug the printer and store it in a shady area, away from rain, wind and sunlight.
Q.
What is the difference between "crv" and "stl" files?
The crv file is the default file by carima slicer. Supporter and models are recognized separately and stored
A.
so that they can be modified at any time when the supporter work is completed and saved. In the case of
the stl file, supporters are saved as one mass with the model and cannot be modified after saving.
IMD AGENCY MANUAL
sales@carima.com
02-3663-8877
Q.
How much resin do I need?
Pour as much resin as necessary every time
A.
you use the printer. Filling the vat with 1/3
of resin will be sufficient.
Q.
How long can I store the resin?
After opening the resin, the warranty period is
A.
up to 6 months. Keep the resin away from light
exposure, as it can cure when exposed to it.
Q.
The slicing file I've uploaded has a different
resolution.
A.
If the resolution of the device is not
correct, it will not print. Be sure to check the
resolution and build size of the device in
'configuration' before slicing.
22
www.carima.com