Finishing Prints; Demounting; Post-Processing - Carima IMD Manual

FINISHING PRINTS

Finishing Prints
Once the print is completed, remove the output from the build plate.
Wear nitrile gloves when removing the output.

Demounting

When the output is complete, remove the output from the build plate.
01
Separation
Turn the pin
counterclockwise
Once the print is completed, the plate moves up.
Rotate the build plate fixing pin counterclockwise
to remove the build plate.

POST-PROCESSING

After removing the output, post-processing such as washing, drying, removing the supporters and
curing has to take place. Wear nitrile gloves and remove the prints.
01
The resin remains when the output is completed. The remaining resin can be cleaned with
alcohol(IPA, 95% or higher). The higher the alcohol concentration, better the wash.
Washing
* Washing can be done through soaking the outprint in alcohol or by using a sprayer with
alcohol. Be aware, for the output should not be in alcohol for more than an hour.
For detailed wash, use thin brush to remove resins.
Use eco-friendly detergent or water when using Carima's Nontoxic resin(CMYK/W).
* Use protective equipment when using toxic alcohol(IPA).
IMD AGENCY MANUAL
sales@carima.com
02-3663-8877
02
Demounting
Remove the build plate upside down, to prevent the
remaining resin from falling. To prevent damages,
carefully use the scraper provided to remove the
output.
* Be careful when using the cutter and scraper.
18
www.carima.com