Cleaning The Condensate Trap - Bosch Condens 8300i W Installation And Maintenance Instructions Manual

Inspection and maintenance
9.17

Cleaning the condensate trap

WARNING
Danger to life due to poisoning!
If the condensate trap is not filled, poisonous flue gas can escape.
▶ Only turn off the trap filling program during maintenance, and turn it
back on at the end of maintenance.
▶ Make sure that the condensate drains off properly.
Damages resulting from an insufficiently cleaned condensate trap are
excluded from the warranty.
▶ Clean the condensate trap regularly.
▶ Unlock the condensate trap.
▶ Pull the hose from the condensate trap.
▶ Tilt the condensate trap anti-clockwise for draining.
1.
Fig. 60 Removing the condensate trap
▶ Clean the condensate trap.
▶ Remove and clean dirt trap at the bottom.
▶ Reinsert the dirt trap and check for tightness.
▶ Check the aperture towards the heat exchanger.
▶ Remove the gasket on the top of the condensate trap.
▶ Check the gasket for cracks, deformation or breakage and replace if
required.
46
▶ Align the new gasket correctly with the condensate trap.
Fig. 61 Aligning the new gasket with the condensate trap
▶ Press on the gasket in the required order.
When the gasket is correctly inserted, the pin is visible in the recess
and is flush with the top edge of the gasket.
2.
3.
0010026772-002
Fig. 62 Pressing on the gasket
▶ Check the condensate hose and clean if required.
▶ Fill the condensate trap with approx. 250 ml water.
0010019151-002
1.
2.
3.
0010019159-002
Condens 8300i W – 6721841531 (2022/10)
2.