Disposal And Recycling - EINHELL GE-HC 18 Li T Operating Instructions Manual

risk of an electric shock.
8.2 Maintenance
8.2.1 Chain saw attachment
Replacing the chain and bar
The chain saw bar needs to be replaced if the
guide groove of the bar is worn. Proceed as
described in the section "Assembly of the bar and
the saw chain".
Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis
in order to guard against overheating and the
damage this can cause to the bar and the saw
chain. Point the tip of the bar at a smooth surface
(a board or a cut tree face) and allow the chain
saw to run. If you see a growing oil stain on the
smooth surface, the automatic chain lubrication
system is working properly. If no clear oil trace is
evident then please refer to the corresponding
instructions in "Troubleshooting". If the information
contained there still fails to remedy the situation,
please contact a service center or another
similarly qualifi ed workshop.
Important! Do not actually touch the surface with
the tip of the bar when performing this test. Keep
a safe distance of approx. 7.9" (20 cm).
Sharpening the saw chain
Working eff ectively with the chain saw is only
possible if the saw chain is in good condition and
sharp. This also reduces the risk of kickback. The
chain can be re-sharpened by any dealer. Do not
attempt to sharpen the chain yourself unless you
have the necessary special tools and experience.

9. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GE_HC_18_Li_T_Part1_USA_SPK7.indb 17 Anl_GE_HC_18_Li_T_Part1_USA_SPK7.indb 17
EN
10. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 17 -
23.11.2022 14:22:54 23.11.2022 14:22:54