Connecting The Water Supply Hose; Note For Connection; Checking The Rubber Seal - LG F6V910RTSA Owner's Manual

global_main.book.book Page 71 Sunday, October 16, 2022 3:39 PM

Note for Connection

Connecting the Water Supply Hose

• Water pressure must be between 50
kPa and 800 kPa (0.5‒8.0 kgf/cm²). If
the water pressure is more than 800
kPa, a decompression device should
be installed.
• Periodically check the condition of the
water supply hose and replace the
water supply hose if necessary.
NOTE
• Do not overtighten the water supply
hose or use mechanical devices to
tighten onto the inlet valves.
• No further backflow protection
required for connection to the water
inlet.

Checking the Rubber Seal

Two rubber seals are supplied with
A
the water supply hose. They are used to
prevent water leaks. Connection to taps
is sufficiently tight.
• Do not use mechanical devices such as
multi grips to tighten the water supply
hose. Ensure that the curved end of
Connecting the Water Supply Hose
the water supply hose is connected to
the appliance.
71