Table of Contents
Advertisement
global_main.book.book Page 58 Sunday, October 16, 2022 3:39 PM
Before Calling for Service
Symptoms
Appliance is not
filling properly.
Appliance does
not drain water.
Detergent is not
dispensed
completely or not
dispensed at all.
Cycle time is
longer than usual.
Cycle end is
delayed
58
Possible Cause & Solution
Insufficient water supply.
• Make sure that water tap is turned on all the way.
Kinked drain hose.
• Ensure that the drain hose is not kinked.
Drain located higher than 1 m above the floor.
• Make sure that the drain hose is no higher than 1 m above
the bottom of the appliance.
Too much detergent is used.
• Follow the guidelines provided by the detergent
manufacturer.
Drain Pump Filter may be blocked.
• Clean the Drain filter.
The load is too small.
• Add more items to allow the appliance to balance the loads.
Heavy articles are mixed with lighter items.
• Always try to wash articles with similar weight in order to
allow the appliance to evenly distribute the weight of the
load for spinning.
The load is out of balance.
• Manually redistribute the load if articles have become
tangled.
Unbalance is detected or suds removing programme is
on.
• This is normal. The time remaining shown on the display is
only an estimated duration. Actual time may vary.
Advertisement
Table of Contents
