Activating Network Connection; Using The Appliance Remotely - LG F6V910RTSA Owner's Manual

global_main.book.book Page 41 Sunday, October 16, 2022 3:39 PM
operating system (OS) and the
manufacturer.
• If the security protocol of the router is
set to WEP, network setup may fail.
Change the security protocol (WPA2 is
recommended), and connect the
product again.
Activating Network
Connection
1
Run the LG ThinQ application.
2
Select and touch the Front Load
Washer in the application.
3
Press the Power button on the
control panel.
4
Press and hold Wi-Fi button for 3
seconds on the control panel.
• The Wi-Fi LED blinks during the
connection process.
Using the Appliance
Remotely
Remote Start
Use a smartphone to control your
appliance remotely. You can also
monitor your cycle operation so you
know how much time is left in the cycle.
Using this function
1
Put the clothes into the drum.
LG ThinQ Application
• If desired, add bleach or fabric
softener to the appropriate areas of
the dispenser.
2
Press the Power button.
3
Press and hold Remote Start button
for 3 seconds to enable the remote
control function.
4
Start a cycle from the LG ThinQ
application on your smartphone.
NOTE
• Once this function is enabled, you can
only start a cycle from the LG ThinQ
smartphone application. If the cycle is
not started, the appliance will wait to
start the cycle until it is turned off
remotely from the application or this
function is disabled.
• If the door has been opened, you can
not start a cycle remotely.
Disable this function manually
When this function is activated, press
and hold the Remote Start button for 3
seconds.
41