Transportation - Nax Power Products NAX 950V Manual

Cleaning agents and solvents such as gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household
detergents that contain ammonia can damage plastic components.
Lubrication is not required because the motor is equipped with bearings that are lubricated throughout its life.
LOCK REMOVAL
Leaves and fresh plant parts can clog the garden vacuum cleaner.
To clean the air inlet:
1. Take off the bag.
2. Clean the outside parts of the air outlet.
3. Use a bottle brush or other similar equipment to remove dirt residues from the inside of the air outlet and remove
objects with a blunt tool without sharp edges.
To clean the suction pipe:
1. Carefully remove the suction pipe.
2. Tap inside of the the vacuum cleaner pipe and clean it thoroughly.
3. Remove any dirt residue from the impeller with a brush and remove objects with blunt tools without sharp edges.
4. Check that the impeller can rotate freely and is not damaged. A damaged impeller should be replaced by
an authorized service center.
ATTENTION: If the device suddenly stops during operation and stops sucking, it must be turned off immediately. If
the device does not turn on after cleaning the suction pipe, contact a service center.
BAG REPLACEMENT
A damaged bag must be replaced immediately. Use only original bags. Otherwise the warranty is void.
STORAGE
Attention! The vacuum cleaner should be stored in a well-ventilated room in a dry, dust-free place out of reach of
children. Only a functional device should be stored; rectify faults before storage.
Keep the tool out of the reach of children.
Do not store the device in direct sunlight, store it in a dark place or under low-light conditions.
Do not cover the device with nylon bags as it may get wet.
The equipment should be thoroughly cleaned at the end of the season and before winter storage. Clean the bag by removing
it, emptying and washing with neutral soap under warm water. After drying, attach the bag again.
For better storage, the suction pipe can be unfolded.
If the vacum cleaner is not in use, it should be stored clean, on a flat and dry surface. If the break in operation is longer than
3 months it is necessary to:
 empty and clean the fuel tank,
 dispose of fuel in accordance with applicable regulations,
 thoroughly clean the device, especially the cylinder fins and air filter.

TRANSPORTATION

Preparation for transport
 Turn off the vacuum cleaner before moving it.
 Keep the vacuum cleaner away from your body.
 For transport, the saw must be secured with transport belts, and if possible, transport the scythe folded in its original
packaging.
EN 41