Safety And Producer's Liability; Residual Risk - Nax Power Products NAX 950V Manual

MAINTENANCE AND STORAGE
WARNING!

Before attempting any repair or maintenance, make sure the vacuum cleaner. engine has stopped and is cold.
Disconnect the high voltage cable from the spark plug to prevent accidental starting of the engine.

Remember that there may be fuel in the machine's tank. Safety rules for handling fuel are described in this manual
in the section "Safety in handling fuel".

Keep all nuts, bolts and screws in good condition to make sure that the device will work safely.

After finishing work clean the device.
CAUTION!
Always make sure that the device is turned off before performing any inspection or maintenance. Use a fine brush, tuft, or
cloth to clean the housing of the dust, you can clean the vacuum cleaner with compressed air.
Cleaning with a damp cloth is allowed, however, provided that the device is dried immediately after this operation. Metal
parts must be protected with oil. Regularly clean the ventilation holes with compressed dry air. Do not insert sharp objects
into the ventilation openings.
After finishing work, please:

Wipe the ventilation holes and leave them free of dirt.

Wipe the vacuum cleaner with a dry cloth.
CAUTION! Never use aggressive or corrosive cleaning detergents as they may damage the plastic parts of the
device. It is unacceptable to clean the vacuum cleaner with a water jet, water may damage the electrical parts of the vacuum
cleaner.
Cleaning agents and solvents such as gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household
detergents that contain ammonia can damage plastic components.
The vacuum cleaner must be stored in a well-ventilated room in a dry, dust-free place. Only a functional device should be
stored; rectify faults before storage.
IN CASE OF AN ACCIDENT OR FAILURE
In the event of an accident, stop / turn off the machine immediately and call for help (if required).
In the event of a fault, stop / turn off the machine and contact an authorized service center to rectify the fault.

SAFETY AND PRODUCER'S LIABILITY

Any use of the vacuum cleaner other than described in this manual is considered improper and the manufacturer is not liable
for any damage or damages resulting from such a procedure. Proper use also includes respecting the operating,
maintenance, storage and repair conditions established by the manufacturer. To prevent accidents, all safety precautions
and hazard avoidance must be followed.
Any changes in the construction of the device made by the user may affect the safety of use of the machine and release the
manufacturer from liability for damage or injuries.

RESIDUAL RISK

Despite the fact that the machine manufacturer bears responsibility for its construction eliminating danger, certain elements
of risk during operation are unavoidable. The residual risk arises from the erroneous behavior of the machine's operator. The
greatest danger occurs when performing the following prohibited activities:
• use of the machine for other purposes than described in the Operation Manual,
• when other people, especially children or animals are nearby,
• use of the device by people not acquainted with the operation's manual,
• using the device without proper, protecting operating clothing and footwear protecting foot,
• using the device with damaged guards or the casing and without properly installed safety devices, e.g. shield guards
etc.
When observing the instructions in the operating manual, the residual hazards of using the machine may be eliminated.
There is a risk in case of failure to comply with the above recommendations.
36 EN