Troubleshooting - Panasonic MC-SBV01W543 Operating Instructions Manual

Troubleshooting

Please check the following items before contacting the retailer for repair.
Problem
It cannot be operated
It stops running even
though nothing is
being done to it
The floor nozzle's
agitator (brush) stops
moving
The suction power is
weak even in the
"HIGH" operating
mode
The suction power
from the floor nozzle is
weak
16
● Is the battery depleted? (P. 8)
● In order to prevent the motor from overheating, is the safeguard device working?
→ ① Press "OFF"
② Wait 5 to 30 minutes (the motor cools down, and the safeguard device is released)
③ Investigate what caused (P. 8) the safeguard device to work
◦ C ontinuously operated with a lot of dust accumulated in the dust box
→ Throw away the debris in the dust box, and clean it (P. 12)
◦ T he extension wand and nozzle are clogged up with debris → Remove the debris
◦ U sed with foreign matter entwined in the agitator (brush)
→ Remove the foreign matter
● In order to prevent the battery from overheating, is the safeguard device working?
→ ① Press "OFF"
② Wait 5 to 30 minutes (the battery cools down, and the safeguard device is released)
③ Investigate what caused (P. 8) the safeguard device to work
◦ C ontinuously operated with a lot of dust accumulated in the dust box
→ Throw away the debris in the dust box, and clean it (P. 12)
◦ T he extension wand and nozzle are clogged up with debris → Remove the debris
● I f the floor nozzle rises up from the floor, the agitator (brush) will stop
rotating for safety.
● Have you been using it so that the floor nozzle fell off?
→ Lift the floor nozzle up once, and slowly lower it.
● Are debris or strings wrapped around, or jamming up the agitator
(brush)? (P. 14)
● Depending on the floor surface types, such as long-pile carpets, the
agitator (brush) might not rotate, or it might slow down.
● Press "OFF", and retry operating it.
● Is each filter clogged up?
→ Clean them (P. 12, 15)
● Is the dust box securely set in?
● Are the air intake passage, extension wand, and floor nozzle clogged up with debris?
→ Remove the clogged up debris with a thin stick, etc.
Air intake
passage
● Is it full of debris?
● Is the dust box clogged up?
→ Clean it (P. 12)
Check here