Connecting Jig(S) - Panasonic YD-350GY4 Operating Instructions Manual

6.4 Connecting jig(s)

The location of
6.4.1
There are two types of jig terminals (Jig terminals 1 and 2)
（1） Jig terminal 1
To send out a command for the emergency stop and
temporary stopping from a jig or another device.
To send out the current detection signal to a jig or another
device.
Location: On the chassis inside the product.
（2） Jig terminal 2
To install an external voltmeter or ammeter.
Location: On the chassis inside the product.
Note:
● Keep the communication cables away from the welding
arc area, the welding torch, the base-material-side
cable, etc. to prevent troubles caused by incorporation
of the high frequency wave. And keep the wiring length
within 10m.
● Lead wires from the wiring port. (Make a cut in the
grommet wall to insert wires.)
Layout of jig terminals
6.4.2
* Connect the start signal of this product to the torch switch receptacle of the wire feeder.
When touching a printed circuit board, observe the following item to prevent
electrostatic destruction of the printed circuit board.
Before starting an operation, for example, touch any metal part of the case
with your hand to discharge static electricity.
jig terminals
Connection
19