6 Connection
The installation shall be done by qualified installation personnel and should conform to
●
all national andlocal codes.
Important
Type and capacity of protection devices, such as breaker and fuse, to be applied
●
should conform to all national and local codes.
Type and size of cables to be applied should conform to all national and local codes.
●
Make sure to turn off the switches of this product and the distribution box before starting
●
connections.
Do not perform any connection work with wet hands.
●
Make sure to insulate all bare current-carrying parts like joints and so on by tape, etc.
●
Do not apply undue force to the cables and wires.
●
Avoid contact with the welding arc part at wiring.
●
For safety reasons, provide base material with grounding work. Wiring and grounding
●
work should be done by qualified electricians.
6.1 The connection of output cable
Connecting cable from base metal
Connect
●
cable from the base metal to the base metal terminal (-).
After connection, insulate the cable connections with insulation tape.
●
Use a cable of 35 mm
●
Make sure to use one whose cross section and length conform to the applied connecting cable.
●
Make sure to attach the proper clamp terminal.
●
Connecting torch cable
Connect torch cable from the wire feeder to the torch ter- minal (+) with the attached M10 bolt.
●
After connection, insulate the cable connections with insulation tape.
●
Connecting feeder cable
Put in the plug of the feeder cable from the wire feeder to the feeder connector.
●
ouching current carrying parts may cause a fatal accident like an electric
T
shock, burn injury and so on. To prevent physical accidents like an electric
shock, burn injury and so on, make sure to observe the followings.
Observe the followings to prevent a fire caused by overheat of cables.
● Use cables with specified size or larger.
● Fasten all cable connections securely.
2
or more for welding or a specified tough rubber sheath cable (excluding vyniletype)
Connection
17