Connection Method - Panasonic YT-40MFW Operating Instructions Manual

3

connection method

3.1 Connection of welding gun cable
1. Please install a long wire feed tube, see 5.1 for the
installation method;
2. Connect the lock nut on the welding torch to the
connection part on the side of the wire feeder, and
tighten it securely to prevent loosening
1.Before connecting, use an air gun or other tools to
blow off the spatter and welding wire powder on
both sides of the connection. If there is foreign
matter on the power-on surface that affects the
conductive effect, if the conductive surface is
scratched or knocked, please replace it with a new
"connector body", otherwise it will cause a fire due
to the heating of the conductive surface.
2.When connecting, pay attention to confirm the
position of the pin, and make sure that the pin is
inserted into the European connector (wire feeder
side), otherwise it will affect the use effect.
3.2 Connection of welding torch water pipe
Confirm the installation status of the water supply pipe and drain pipe of the welding torch.
The water supply pipe is connected with the water supply pipe of the cooling water
circulation device, and the drain pipe is connected with the return pipe of the cooling water
circulation device. The inlet pipe and the return pipe are quick-plug structure. The sound
indicates that the connection is in place. At this time, pull back the water supply and drain
pipe to confirm whether it is connected in place. After connection, please reconfirm the
correctness of the water inlet pipe connection.
1. The virtual connection of the water pipe will cause water leakage and cause burns;
2. Incorrect connection of water pipes may cause scalds, torch burns, and even fire and
electric shock;
3. When using in an environment where icing is possible, in order to prevent icing from
damaging the welding torch device, please use antifreeze as the coolant. When it is not
used for a long time, please use compressed air to blow the coolant out from the water
supply port.
.
3
Figure2
4
1
Con
1
Nut
2 Nut
3 Torch switch
4 Connect the body
2
3
ductor