2.3.9 Oil Filters Change
WARNING
Hot oil can cause severe burns. DO NOT
allow hot oil to contact the skin. When
changing oil, wear protective gloves.
CAUTION
Volvo-branded oil filters are designed to
provide the proper level of filtration and
protection for Volvo engines. Filters that do
not meet the same stringent requirements
may cause unsatisfactory results.
Clean around the oil filter housing and
remove the filters using the oil filter
wrench or the oil filter socket.
FIGURE 8: OIL FILTER WRENCH
Prefill the new oil filters with approved
engine oil. Refer to Figure 9, also,
lubricate the filter gaskets with engine oil
(1). Hand tightens the oil filters until they
contact the sealing surface of the oil filter
housing (2). Manually tighten the oil filters
an additional ¾ to 1 full turn (3).
FIGURE 9: OIL FILTER REPLACEMENT
Start the engine and check for leaks
around the oil filter housing and filters.
Check the oil level. Add approved engine
oil
to
the
necessary. Do not overfill.
2.3.10 Checking the Oil Level
Ensure that the vehicle is parked on level
ground before checking the oil level. Wait five
minutes after shutting off the engine and then
proceed with checking the oil.
CAUTION
DO NOT let the oil level fall below the marking
on the dipstick. DO NOT overfills so the level
is above the upper marking on the dipstick.
This could lead to excessive oil temperature
and/or poor crankcase breather performance.
Add oil through the oil filler pipe as required in
order to maintain level within the safe range.
PA1621 Maintenance Manual All Series | January 2017
SECTION 01 : ENGINE
recommended
level,
17
if