Advertisement
FAQ
Q1: Why doesn't the login page appear after entering http://netlogin.link?
A: Make sure your PC is set to obtain IP address automatically.
A: Ensure you entered the correct website.
Q2: What can I do if I cannot access the Internet?
A: Make sure your Internet works normally. If not, contact your ISP (Internet Service Provider)
A: Initiate your browser, enter "192.168.10.1" or "netlogin.link", and then set up the following
quick start guide.
A: Reboot your device and try again.
Q3: How do I restore the device to factory default setting?
A: Press and hold the reset button of the device for 6 seconds.
Q4: Why is the flow monitoring is inaccurate?
A: The Hardware NAT default setting's open status leads to the absence of monitored
data. If you want keep the flow monitoring accurate, you will need to turn off the Hardware
NAT Settings function manually, which inevitably will increase the CPU usage.
Q5: Why can't I use the WPS function in EasyMesh mode?
A: EasyMesh mode only supports Mesh networking pairing, and router mode only supports
WPS pairing.
Q6: How to resolve the conflict between WAN IP and LAN IP?
A: When the router acts as a secondary router and obtains IP through DHCP to access the
Internet, there is a possibility that the IP obtained by the router's WAN and the IP network
segment of the router's LAN are the same. For example, the upper-level router uses
192.168.10.1, and the IP range assigned by the local router is 192.168.10.xx, and the local
router is also 192.168.10.1, which will affect the normal network function of the router. In this
case, when the router detects a conflict, it will adjust the LAN segment, usually adding one
to the corresponding IP segment to change to 192.168.11.1. The customer can also modify it
according to the actual situation to avoid this conflict.
40
Advertisement
