Maintenance - Market Forge Industries UniVerse Skillet 30P-STGL Installation & Operation Manual

Maintenance

Maintenance
Disconnect the power supply to the appliance before cleaning or servicing.
Replacement of Temperature Control
1. Place circuit breaker in off position.
2. Remove skirted dial knob by loosening two set screws in the knob. (Use a 5/64 Hex key to loosen screws).
3. Tilt control box up by first removing two pan head screws in the lower front of the console. Use the prop up arm
located inside, in the rear vertical column, to keep the console cover tilted open.
4. Disconnect all wire leads from temperature control.
5. Remove temperature control by removing two (2) pan head screws from side of control box.
6. Install new temperature control and reverse steps 1 - 5.
Adjustment of Interlock Switch
1. Tilt skillet pan all the way in the downright position.
2. Place circuit breaker in off position.
3. Tilt control box up by first removing two pan head screws in the lower front of the console. Use the prop arm located
inside, in the rear vertical column, to keep the console cover tilted open.
4. To reduce the angle where the switch disengages when the pan is tilted, use a pair of heavy duty needle nose pliers and
lightly bend the tilt tab on the trunnion up. To increase the angle, bend the tilt-tab down. Test by tilting the pan and checking
at what angle the switch clicks. The switch should click off at approximately 10° tilt of the pan from the horizontal position.
5. Close and fasten the control console by tightening the two screws at the lower front of the box.
6. Place circuit breaker in on position.
Cleaning
1. The skillet should be cleaned daily.
2. Wash the skillet with a mild detergent and hot water. If food is stuck to the surface of the skillet pan, soak it and use a
little heat to loosen the food. Then, wash with clear water and dry.
3. Be sure to wash under the skillet cover and rinse with clean water.
4. Check the skillet pouring lip corners to be sure they are clean. Also, wash around the exterior of the skillet. Rinse with
clean water and air dry.
Adjustment of Motor Tilt-stop Switches
1. Tilt skillet pan all the way in the down or horizontal position until the stops in the back engage.
2. Tilt control box cover up by first removing two pan head screws in the lower front of the console. Use the prop arm located inside,
in the rear vertical column, to keep the console cover tilted open. Caution, circuit is live! Electrical power has not been turned off.
3. Remove control console lower side cover to expose motor, tilt cam and switches.
4. Using a 9/64 hex key, loosen the two set screws on the tilt cam located on the outside hub of the tilt gear.
5. Turn the cam so that one of the arms just engages the upper-right tilt switch as the arm is turned clockwise. Hold the
cam/arm in that location and tighten the set screws.
6. Using the tilt UP/DOWN switch on the control panel, test the full travel up and down on the pan. The motor should stop
just before the pan back stops engage in the horizontal position. It should stop at about 80° in the up or vertical position.
7. Repeat steps 4 to 6 until motor tilt stops as described in step 6.
8. Replace the control console lower side cover in its original position. Close and fasten the control console by tightening
the two screws at the lower front of the box.
10
PAGE OF 16
Leads should be marked appropriately to facilitate re-installation.
INSTALLATION & OPERATION MANUAL 10158 REV 4 (09/21)
UniVerse Skillet™ Gas Tilting Skillets
WARNING
NOTICE