Trouble-Shooting; Maintenance - Market Forge Industries 30P-STEL Owner's Manual

PROBLEM
Uneven Heating
Signal Light Out
Unit Fails to Heat
IMPORTANT!: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING.
DAILY CLEANING:
1. The skillet should be cleaned daily.
2. Wash the skillet with a mild detergent and hot water. If food is stuck to the surface of the skillet pan, soak it and use a
little heat to loosen the food. Then, wash with clean water and whip dry.
3. Be sure to wash under the skillet cover and rinse with clean water.
4. Check the skillet pouring lip corners to be sure they are clean. Also, wash around the exterior of the skillet. Rinse with
clean water and air dry.
WARNING!: DO NOT GET WATER ON WIRING OR CONTROLS. BE SURE TO WASH INSIDE OF SKILLET PAN, INSIDE OF
COVER INCLUDING UNDER DRIP-LIP, AND POURING SPOUT AREA.
WARNING!: THE SKILLET PAN AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING AND SERVICING
THE TILT SKILLET.
WARNING!: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDI-
CATE THAT YOU ARE WORKING ON THE CIRCUIT BEFORE PERFORMING ANY MAINTENANCE.
ADJUSTMENT NOTE!: ALL TILTING SKILLETS ARE ADJUSTED AT THE FACTORY. AT LEAST TWICE A YEAR HAVE AN
AUTHORIZED SERVICE PERSON CLEAN AND ADJUST THE TILTING SKILLET FOR MAXIMUM PERFORMANCE.

TROUBLE-SHOOTING

PROBABLE CAUSE
a. Defective element.
b. Uneven torque of element
clamp plate nuts.
c. Temperature control out of
calibration or defective.
a. Burnt out bulb.
b. Defective temperature control
or thermocouple.
c. Loose electrical connection.
a. Circuit breaker is off.
b. Malfunction of interlock
switch.
c. Contactor does not pull in.
d. Defective temperature control
or thermocouple.

MAINTENANCE

7
REMEDY
a. Replace element.
b. Re-torque element clamp
plate nuts on bottom of skillet
(5' pounds only/nut).
c. Calibrate or replace.
a. Replace.
b. Replace.
c. Repair.
a. Reset circuit breaker.
b. Adjust or replace.
c. Replace contactor.
d. Replace temperature control
or thermocouple.