Table of Contents
Advertisement
IMPORTANT! ALWAYS ENSURE SECURITY CLIPS ARE USED ON ALL WATER AND CO2
CONNECTIONS.
Attach the regulator to the
disposable CO2 bottle,
ensuring the regulator is closed.
We recommend between 3.5 –
5 bar. Do not exceed 5 bar
pressure.
Level Sensor Assembly
Connect the assembled CO2
bottle and regulator to the
machine using 1/4 inch pipe.
Flush through approximately 10
litres of water. Check and adjust
the CO2 pressure accordingly.
After completing the water
installation, turn on the soda
power switch and the pump will
run. Do not open the regulator
valve until the carbonated
switch has been turned on.
It will be necessary to leave the
machine for up to 1 hour for
sparkling water to develop, by
absorbing the CO2.
Advertisement
Table of Contents
