Leak Detection - Borg & Overström B5 Install & Operation Manual

When the external
cleaning (minimum 5
minutes) is
completed, flush the
machine using the cold
button with
clean water until the
dispense water runs
clear. Repeat
briefly with the ambient
button (and sparkling
button if
present).

Leak Detection

NOTE: This machine is equipped with a leakage detection device. When leaking is detected, the
dispense operation will be cut off automatically. This is indicated by a blue LED flashing at the base of the
tap.
To reset:
Turn off water and
remove the service
filter. Retain service
filter for reuse.
Fit new filter. Turn on
incoming water
supply.
Pre-flush the new filter
to waste using the
ambient button (and
sparkling button if
present) until the water
appears clear and is
free of air. Flush
through a small amount
of water to check all
functions.