Storage Cabinet - Borg & Overström B5 Install & Operation Manual

This shows the correct and factory default set
point. Although adjustment is possible (clockwise
reduces the temperature and anti-clockwise
increases the
water temperature), this correct default setting is to
ensure optimum performance and reliability.
Unauthorised alternative settings could cause
technical issues and invalidate the warranty.
Chilled
On/Off Switch: at upper rear of machine,
switches cooling operation on/off.
Cold Thermostat: at rear of machine.
Cold Button: press to dispense cold water.
Green LED (Top): Colours to show cooling
operation is switched on.
Green LED (Bottom): Colours to show when
compressor is operating/water is above set point.
10A Fuse: On rear of machine, integral with IEC
socket.
Ambient
Ambient Button: Press to dispense ambient water.
Sparkling
Soda: Switches sparkling operation on/off.
Sparkling Button: Press to dispense sparkling water

Storage Cabinet

Yellow LED (bottom RH): Colours to show the
sparkling operation is switched on.
Hot
On/Off Switch: The hot water heating mode is
controlled by a switch on the back of the unit, next
to the cooling mode switch. This switch is labelled
"Hot".
Hot Thermostat: regulated by a pre-set,
nonadjustable sensor on the tank.
Hot Button: press to dispense hot water.
Lock Button: toggles on and off the dispense of hot
water.
Red LED (on hot water icon): Colours to show
heating mode is enabled.
Red LED (marked heating): Colours to show
heating element is active according to thermostatic
demand.