Table of Contents
Advertisement
Sanitisation Guide
NOTE: Before beginning the sanitation process please ensure that water is turned off at the mains and
refer to the MSDS document for further information. Use bioguard hand gel and ensure gloves are worn.
Briefly press
cold/ambient
dispense button to
release
internal water pressure
from the machine.
Turn on incoming
water, allow service
cartridge/doser to fill.
Remove the existing
filter.
Dispense water using
the cold button until the
water appears pink.
Briefly press the
ambient button too.
Repeat with sparkling
button if present.
Add 25 ml of
Sterizen® 30 Internal
Water Cooler Sanitiser
fluid to a clean and
empty service filter
cartridge.
Leave the solution
inside machine for
sanitisation to take
effect (minimum 5
minutes) while
thoroughly cleaning the
machine externally,
pay particular attention
to the dispense faucet
and button controls.
Connect to machine.
Remember to include
the drip tray. Empty the
Waste Overflow
System and flush
through with a small
amount of sanitisation
fluid if needed.
Advertisement
Table of Contents
