Table of Contents
Advertisement
INTRODUCTION
This manual provides instructions for configuring the
Ericsson GE Trunking Card Shelf (GETC™), part number
19D901868G3 and G4, for station or repeater operation.
The manual is applicable to GETC 1e hardware platforms
installed in wideband or narrow band 800 MHz, 900 MHz,
UHF, and VHF stations.
includes an operational description and procedures for
installing, upgrading, and verifying the hardware, firmware
and software installed in the GETC.
The GETC 1e platform consists of the following sub-
assemblies:
•
Logic Board 19D904266G1 (used with Group 3) or
19D904266G4 (used with Group 4).
•
GETC
Expansion
19D903536P1.
•
Regulator Board 19C366861G2.
•
Rockwell Modem 19A705178P1 (optional). (The
modem is required when the GETC is used in an
EDACS Voted or Simulcast System or if it is part
of an EDACS Network)
All references to GETC in this manual refer GETC 1e
platform and the combination of GETC Logic board and
Turbo board installed in the GETC Shelf.
COMPATIBILITY
Software
The following software is required for GETCs used in
the Station GETC configuration:
WideBand 9600 Baud Stations and Satellite Receivers
GETC LOGIC BOARD
EPROM, U2
349A9607G1
349A9607G2
349A9607G4
Narrow Band 4800 Baud Stations
GETC LOGIC BOARD
EPROM, U2
19A705595G8
349A9607G4
The information presented
Module
(Turbo
Board)
TURBO BOARD
SOFTWARE
344A4414G2 (or later)
344A4414G3 (or later)
344A4414G4 (or later)
TURBO BOARD
SOFTWARE
344A4414G1
344A4414G4 (or later)
Narrow Band 9600 Baud Stations, Satellite Receivers, &
4800 Baud ETSI Station
GETC LOGIC BOARD
EPROM, U2
349A9607G4
Refer to SRN1060, SRN1061 and SRN1062 for
compatibility of GETC 1e with other EDACS platforms. To
ensure system compatibility, all repeaters and Satellite
Receivers should have the same firmware versions installed.
Also, for proper Voted or Simulcast operation, Test Unit
Software 19A705272 Group 6 is required.
NOTE
Software used in the GETC is subject to changes
resulting from improvements or enhancements.
When upgrading the software, the procedures
provided in the accompanying Software Release
Notes take precedence over this manual.
Hardware
The hardware configuration depends on the following
EPROM firmware:
Wideband 9600 Baud Applications using 349A9607G2
(or earlier)
Logic Board
Turbo Board
Narrow Band 9600 Baud Applications using
19A705595G8
Logic Board
Turbo Board
Wideband and Narrow Band 9600 or 4800 Baud
Applications using 349A9607G4 (or later)
Logic Board
Turbo Board
RELATED PUBLICATIONS
It may be necessary to consult one or more of the
following documents during the installation process. These
manuals will also provide additional guidance if you
encounter technical difficulties during the configuration
process.
LBI-38988
TURBO BOARD
SOFTWARE
344A4414G4 (or later)
NOTE
19D904266G1
19D903536P1
All
All
19D904266G4
19D903536P1
7
Advertisement
Table of Contents
