Electrolux ERN3011FOW User Manual page 14

14 www.electrolux.com
9.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
9.3 Ventilation requirements
The airflow behind the appliance must be
sufficient.
5 cm
CAUTION!
Refer to the assembly
instructions for the
installation.
9.4 Door reversibility
1. Loosen and remove the upper pin
and the spacer.
min.
200 cm 2
min.
200 cm
2. Remove the door.
3. Remove the lower spacer.
4. Loosen the lower pin with a key.
5. Tighten the lower pin on the opposite
side.
6. Install the lower spacer.
7. Install the door.
8. Tighten the spacer and the upper pin.
2
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.