Getting Started; Charging The Battery Pack - JVC GR-SXM57 Instructions Manual

6
EN
H ook on.
1
BATTERY RELEASE Switch
REFRESH Button
REFRESH Lamp
CH ARGE Lamp
Battery pack
Power Switch
To AC outlet
5
4
Battery pack
BN-V11U*
BN-V12U (optional)
BN-V20U ** (optional)
BN-V400U (optional)
* GR-FXM37/FX12 only.
** Provided with GR-SXM607/SXM57/SXM47/
SX202/SX22 only.
REFRESH:
Charging a battery with some charge remaining reduces that battery ' s capacity. Perform the procedure
below to fully discharge the battery pack before recharging.
1. Perform steps 1 through 3 of " CHARGING THE BATTERY PACK " .
2. Press REFRESH on the camcorder for over 2 seconds. The REFRESH lamp on the camcorder blinks to
indicate discharging has started.
3. When discharging is finished, charging automatically starts and the CHARGE lamp blinks.
When you are not using a battery pack for a long period of time, be sure to fully discharge it before storing
because leaving a battery with some charge left over also reduces performance.
Downloaded from:
2
Push in.
3
To D C IN
connector
AC Adapter
Charging time
approx. 1 hr. 10 min.
approx. 1 hr. 10 min.
approx. 1 hr. 50 min.
approx. 3 hr. 40 min.
https://www.usersmanualguide.com/

GETTING STARTED

Pow er
This camcorder ' s 2-way power supply system lets you
choose the most appropriate source of power. Do not use
provided power supply units with other equipment.
CH ARGIN G TH E BATTERY PACK
1
Make sure the battery pack is attached to the
camcorder. Hook its end to the camcorder
push the battery in until it locks in place
• If the battery pack is attached in the wrong position,
a malfunction may occur.
2
Set the Power Switch to " OFF " . Connect the AC
Adapter to the camcorder
Cord to the AC Adapter
3
Plug the Power Cord into an AC outlet
The CHARGE lamp on the camcorder blinks to
indicate charging has started.
4
When the CHARGE lamp stops blinking but stays lit,
charging is finished. Unplug the Power Cord from the
AC outlet. Disconnect the AC Adapter from the
camcorder.
To D etach The Battery Pack . . .
.... slide BATTERY RELEASE and pull out the battery pack.
N O TES:
● During charging or discharging, the camcorder cannot
be operated.
● Charging and discharging is not possible if the wrong
type of battery is used.
● When charging the battery pack for the first time or after
a long storage period, the CHARGE lamp may not light.
In this case, remove the battery pack from the
camcorder, then try charging again.
● If the battery operation time remains extremely short
even after having been fully charged, the battery is worn
out and needs to be replaced. Please purchase a new
one.
● Using the optional AA-V15EG AC Power Adapter/
Charger, you can charge the BN-V11U/V12U/V20U/
V400U battery pack without the camcorder. However, it
cannot be used as an AC adapter.
For other notes,
1
and
2
.
3
, then connect the Power
4
.
5
.
pg. 44