Table of Contents
Advertisement
The unit must be transported in the upright position to prevent fuel from spilling. Do not lay machine on its
side or top.
Secure or tie down unit using the lifting handle to prevent machine from sliding or tipping over.
Machine may fall and cause damage or injury if lifted incorrectly. Lift using handles at
base of plate.
8. TROUBLE SHOOTING
Problem
1
MOTOR WILL NOT START
2
MOTOR STOPS
3
PETROL MOTOR LACKS POWER
4
WATER FLOW STOPS
5
INSUFFICIENT VIBRATION
6
MACHINEIS NOT MOBING FREELY CHECK THE UNDERSIDE OF THE PLATE FOR A
POSSIBLE CUASES AND CORRECTION
CHECK THE ON/OFF SWITCH TO ENSURE THAT IT IS
SWITCHED 'ON'
CHECK THE FUEL SUPPLY
IF A DIESEL (GASOLINE) ENGINE MOTOR IS FITTED
CHECK THE CRANKCASE OIL AS AN OIL SENSOR
DEVICE IS FITTED TO THESE MOTORS WHICH
PREVENTS STARTING AND STOPS THE MOTOR
WHEN THE OIL LEVEL IS LOW
ENSURE THE SPARK PLUG IGNITION LEAD IS
CONNECTED.
CHECK THE CARBURETTOR JET AND BOWL TO
ENSURE THEY ARE CLEAN.
CHECK THE FUEL SUPPLY
CHECK THAT THE FUEL COCK IS TURNED ON
CHECK THE CONDITION OF THE AIR FILTER
CHECK THE CONDITION OF THE AIR FILTER
CHECK THE CONDITION OF THE SPARK PLUG
INSUFFICIENT WATER
BLOCKAGE IN WATER HOSE OR SPRINKLER BAR
CHECK FOR A SLIPPING OR A MISSING VEE BELT
CHECK THAT THE MOTOR GOVERNED SPEED IS
3,500 RPM
BUILD UP OF MATERIAL
16
Advertisement
Table of Contents
