Table of Contents
Advertisement
6. STORAGE
If the plate compactor will not be used for a period longer than 30 days, following the steps below to prepare
your unit for storage.
1) Drain the fuel tank completely. Stored fuel containing ethanol or MTBE can start to go stale in 30 days.
Stale fuel has high gum content and can clog the carburetor and restrict fuel flow.
2) Start the engine and allow it to run until it stops. This ensures no fuel is left in the carburetor. Run the
engine until it stops. This helps prevent deposits from forming inside the carburetor and possible engine
damage.
3) While the engine is still warm, drain the oil from the engine. Refill with fresh oil of the grade
recommended in the Engine Manual.
4) Allow the engine to cool. Remove the spark plug and put SAE-30 of high quality motor oil into the
cylinder. Pull the starter rope slowly to distribute the oil. Replace the spark plug.
Remove the spark plug and drain all of the oil from the cylinder before attempting to start
the unit after storage.
5) Use clean cloths to clean off the outside of the compactor and to keep the air vents free of obstructions.
Do not use strong detergents or petroleum based cleaners when cleaning plastic parts.
Chemicals can damage plastics.
6) Pull up the spring bolt and fold up the wheels bracket.
7) Carefully fold the handle down. Do not allow control cables to become pinched or bent.
8) Store your plate compactor in upright position in a clean, dry building that has good ventilation.
7. LIFT AND TRANSPORT
See technical data for the weight of the machine.
To avoid burns or fire hazards, let engine cool before lifting / transporting machine or storing indoors.
15
Advertisement
Table of Contents
