Table of Contents
Advertisement
SETUP
1. Install the supplied Rectal probe by inserting the latching plug on the end of
the coiled cord into the plug receptacle on the unit. The plug snaps into
place and cannot be removed without
depressing the latch. (Figure 1).
2. Observe the LCD to see that the probe type
rEC = Rectal is displayed.
3. Insert probe shaft completely into probe
storage channel.
4. Remove the probe from the storage channel.
5. Observe the LCD to see that all display
segments appear followed by the display
of the probe type rEC = Rectal and tem-
perature scale (°C or °F). Replace probe
in storage channel.
6. Insert a box of disposable probe covers
(part number 05031) into the probe
cover storage well.
CHANGING PROBES
• Depress the latch and unplug the probe connector from the thermometer.
• Remove the probe from the storage channel.
• Repeat steps 1 through 6 in the SETUP section.
FEATURES
•
Normal Mode: The thermometer takes rectal temperatures in about 15
seconds. The unit will always operate in Normal mode unless the Mode
button is depressed for more than 2 seconds after the initial temperature is
displayed which changes it to Monitor Mode. Replacing the probe in the
storage channel automatically resets the unit to Normal mode.
•
Monitor Mode: Monitor mode is generally used for long term (continuous)
temperature monitoring or when difficult situations prevent accurate
temperatures from being taken in the Normal mode.
•
Rectal Probe with 4' coiled cord and latching plug.
•
Optional Rectal Probe with 9' coiled cord and latching plug.
•
Mode Button: Recalls the last Normal mode temperature taken, converts
temperatures from °F to °C, switches the unit to Monitor Mode.
4
Advertisement
Table of Contents
