Connecting The Modem Router - Hercules HWGADSL2P-54V2 Manual

HWGADSL2P-54V2 AnnexA

2.3.4. Connecting the Modem Router

1. Connect the Hercules Modem Router's power cable to the power plug 2 and plug the power adapter into
an electrical outlet.
2. Switch on the Hercules Modem Router by pressing the On/Off button 1 located at the back of the unit.
The power LED lights up and the initialization sequence begins. Initialization may take up to 5 minutes,
during which time the WiFi, DSL, Internet and 1-2-3-4 LEDs will light up or flash in succession.
Initialization is complete once the WiFi
3. The DSL LED should flash for a few seconds and then stay lit. This indicates that your Modem Router is
properly synchronized with your ADSL line. If this is not the case, verify that your telephone cable is
properly connected to your ADSL filter and to your Hercules Modem Router. If the problem persists, it may
be that your ADSL line is not activated with your ISP. Please contact your ISP to verify.
4. You may now connect the included Ethernet cable (light gray cable) to one of your Hercules Modem
Router's 4 Ethernet ports
The LED corresponding to the number of the Ethernet port you have selected lights up.
5. The Assistant prompts you to install "Hercules QuickAccess", a utility for quick connection to the
Manager application.
If you do not wish to install this utility, you will only be able to access your Modem Router by
manually entering its address (please see chapter 3.1. Opening the door to WiFi Manager).
LED stays lit.
3 and the Ethernet (RJ-45) port on your computer's network adapter.
Hercules ADSL2/2+ Wireless G Modem Router
User Manual – 13/113
WiFi