Name and Function of Each Component
For the cable type, see the "cable label" attached to the cable bundle.
For the detailed connection procedure, refer to the "Basic Connections" section. (
①
24 VAC
12 VDC
②
① 24 VAC /12 VDC Power cable
② Alarm cables
•
Alarm input cable: Connect an external switch, infrared sensor, or other device to detect alarm
•
Alarm output cable: Connect a buzzer, lamp, or other alarm device.
③ Dip switch (
ON
6
5 4
3
2
Control switch: Use this switch to configure the baud rate and protocol settings.
Address switch: Use this switch to configure the camera control address.
④ Network Socket (LAN: RJ-45, PoE)
⑤ EX-HDD terminal (USB type)
To record video on an external hard disk drive, you must install a 2.5" hard disk drive (SATA) in the
dedicated hard disk case (VA-HDC4000) which is sold separately and then connect the hard disk
drive case.
⑥ HDMI Connector
The terminal outputs super-fine HD (High Definition) video signal. Use the terminal to connect a
high-definition monitor with HDMI interface.
GND
~
~
-
+
conditions such as the entry of an intruder.
Page 11 "Control/Address Settings")
ON
1
1
2 3 4
④
③
5
6 7
8
2
Page 5)
⑤
⑥