WAREMA MSE Compact 2 REG Operating And Installation Instructions

Operating and installation instructions
MSE Compact 2/3/4/6 REG
Keep for future use!
Valid from 1 February 2018
General information
The MSE Compact 2/3/4/6 REG motor control unit is an
electronic control device for the non-floating control of
up to 6 sun shading drives. The MSE and drives have a
230 V AC power supply.
Connected drives can be operated on-site with a suitable
operating element, and control through a sun shading con-
trol system is also possible. The required control voltage
of 24 V DC is generated in the MSEs. Multiple MSEs can
be consolidated to a group and controlled together.
Intended use
The MSE Compact 2/3/4/6 REG motor control unit was
developed to control sun shading systems. The approval
of the manufacturer must be obtained for uses outside of
the purposes listed in these instructions.
Safety instructions
WARNING
The electrical installation must be per-
formed by a certified electrician in ac-
cordance with the electrical installation
regulations published by the Association
of German Electrical Engineers (VDE
0100) or the standards and regulations of
the country in which the device is being
installed. The electrician must observe the
installation instructions included with the
supplied electrical devices.
WARNING
If hazard-free operation cannot be assu-
med, the device may not be started or
must be deactivated. This assumption is
justified if:
 t he housing or the connecting lines show
signs of damage,
 the device is no longer working.
WARNING
It is important to comply with the fol-
lowing points in the interest of personal
safety.
Make sure that no persons or objects are located in the
■
path of any driven parts (blinds, roller shutters, etc.)!
Disconnect the MSE from the operating voltage if
■
cleaning or other maintenance work must be performed!
2018553_b•en•2018-02-01
Function
Tripping a switch on the subassembly can activate one of
the two integrated control programs for the run time for 2
motors each at the same time. The defined run time always
remains effective in pairs, regardless of any group that may
have been built.
On the encoding switch you can perform the following set-
tings:
Motor Switch position
1-2 S1 ON
OFF*
3-4 S2 ON
OFF*
5-6 S3 ON
OFF*
*= factory setting
ON
S1
Fig. 1 factory setting encoding switch
Program 1:
Local operation with time mode:
This control behaviour is especially useful for slat products,
such as external venetian blinds: The sun shading moves
into the corresponding direction after the button is pressed.
If the button is pressed for more than 2.5 seconds, the
control switches to lock mode. The button may then be
released. The sun shading system moves until the fixed run
time of 3 minutes has expired. To release lock mode and
stop the motor, the button opposite the move command
button must be pressed briefly. If you simply want to tilt the
slats, you can briefly touch one of the buttons.
Program 2:
Local operation in permanent mode:
This control behaviour is useful for roller shutters and fabric
products: the sun shading system moves after the local
button is pressed in the corresponding direction and im-
mediately goes into lock mode. The push button may then
be released and the sun shading system will move until
the fixed run time of 3 minutes has expired. To release lock
mode and stop the motor, the button opposite the move
command button must be pressed briefly.
We reserve the right to make technical changes
Programme
permanent mode
time mode
permanent mode
time mode
permanent mode
time mode
S2 S3
1