Operation; Charger Operation; Operation When Charger Is Connected To Power Supply; Troubleshooting - Mitel Desk PDM Charger Installation And Operation Manual

Installation and Operation Manual
Desk PDM Charger

OPERATION

5

5.1 CHARGER OPERATION

5.1.1 OPERATION WHEN CHARGER IS CONNECTED TO POWER
SUPPLY
When the charger is connected to external power supply, the following normal
operation can be done:
Handset charging
1 Connect the charger to the AC power supply.
2 Place a handset in the charging slot to start charging.
Handset disconnection
1 First, tilt the handset forwards.
2 Then, lift the handset upwards.
Note: Do not try to lift the handset upwards before tilting it forwards.
6

TROUBLESHOOTING

For general LED indications, see also
Status LED on the charger is not lit.
Check that power is supplied.
If power is supplied and the status LED is still not lit:
The probable cause is a software error. Send charger for service.
Status LED on the charger is fixed red.
Software error. Send charger for service.
Status LED is flashing red for 3s, then green
Software error. A factory reset has been performed. It may be necessary to set
parameters from WinPDM/CPDM3.
Status LED is flashing red (100 ms on, 800 ms off) for more than 3s
An error occurred during Easy Replacement. Remove handset from charger.
Status LED is flashing red (800 ms on, 100 ms off) for more than 3s
11
5 Operation on page 11.
20/1531-ANF 901 43 D 2017-03-22