Status Indicators - National Instruments FieldPoint FP-DO-410 Operating Instructions Manual

8-channel, 5 to 30 v protected discrete output module

Table of Contents

Reset the Overcurrent Protection Circuit

There are several ways to reset the overcurrent protection circuit,

but first correct the problem that caused the overcurrent protection

circuit to trip. Perform one of the following tasks to reset the

overcurrent protection circuit:

•

Remove the load from the FP-DO-410 (the output remains on).

•

Switch the output to the OFF state.

•

Disconnect field power from the module.

•

Remove the FP-DO-410 from its terminal base.

•

Turn off the network module.

Status Indicators

Figure 4 shows the module label and status indicators. You can

remove the insertable label to see wiring diagrams for the output

channels.

Figure 4. Status Indicators and Module Label

After the module has been inserted into a terminal base (and power

is applied), the green POWER indicator turns on and the

FP-DO-410 informs the network module of its presence. When

the network module recognizes the FP-DO-410, it sends initial

configuration information to the FP-DO-410. After receiving this

initial information, the green READY indicator turns on and the

FP-DO-410 is in its normal operating mode. In addition to the

green POWER and READY indicators, each channel has a

numbered, green, output state indicator which lights when the

channel is in the ON state and a red overcurrent state indicator,

which lights when the channel is in overcurrent protection. For

more information, refer to the section on Overcurrent Protection.

FP-DO-410

Table of Contents