Status Indicators; Isolation And Safety Guidelines - National Instruments FieldPoint FP-DO-400 Operating Instructions Manual

Status Indicators

Figure 5 shows the status indicator LEDs on the [c]FP-DO-400.
The [c]FP-DO-400 has two green status LEDs, POWER and
READY. After you install the FP-DO-400 onto a terminal base
or the cFP-DO-400 onto a backplane and apply power to the
connected network module, the green POWER indicator lights
and the [c]FP-DO-400 informs the network module of its presence.
When the network module recognizes the [c]FP-DO-400, it sends
initial configuration information to the [c]FP-DO-400. After the
[c]FP-DO-400 receives this initial information, the green READY
indicator lights and the module is in normal operating mode.
In addition to the green POWER and READY indicators, each
channel has a numbered, green output state indicator that lights
when the channel is in the ON state.
Upgrading Your FieldPoint Firmware
You may need to upgrade your FieldPoint firmware when you add
new I/O modules to your FieldPoint system. For information on
determining which firmware you need and how to upgrade your
firmware, go to

Isolation and Safety Guidelines

Caution
attempting to connect the [c]FP-DO-400 to any circuits
that may contain hazardous voltages.
This section describes the isolation of the [c]FP-DO-400 and its
compliance with international safety standards. The field wiring
connections are isolated from the backplane and the inter-module
communication bus. The isolation is provided by the module,
which has optical and galvanic isolation barriers designed and
tested to protect against transient fault voltages of up to 2,300 V
FP-DO-400 and cFP-DO-400
Figure 5. Status Indicators
ni.com/info
Read the following information before
and enter
fpmatrix
8
.
.
rms
ni.com