Advertisement
The Turbo£ Stripper is equipped with a Power
-on indicator lamp (1) and an operating Switch
located at the top of the handle. The switch has
a restart protection for low-voltage failures.
If the lamp does not indicate power-on, use another
power socket or check power supply.
Before starting work, cut the floor covering into strips
of about 12 ". You cannot work faster if you cut wider
strips.
To begin, cut one strip crosswise. Then lift the flooring slightly in order to get the blade underneath it.
We recommend to cut the first strip at right angles to the main working direction. By so doing access
to the adjacent strips is made easier.
Cut the strips smaller if the floor covering is bonded very securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the blade has to be changed only if it is
twisted or becomes worn.
The driving wheels are subject to wear. They have to be changed after approximately 16mm (0.6
inch) of the surface has been worn away. Otherwise the working angle of the striking apparatus will
not be correct especially critical with cork or foam backed carpets.
9
Advertisement
