Sinclair TURBO STRIPPER II Operating Manual page 6

3.0 Assembly of Machine & Handle
Insert handle into Turbo II base as shown in diagram.
Tighten wing bolts in handle. Note that bolts are spring loaded to get past
foot pad. Position both bolts facing up as shown in diagram.
3.1 Adjustement Of Handle
To adjust handle, loosen wing bolt on back of handle. Pull knob on side lever and lift torwards
you. Pull locking knob out from back of handle and slide handle up or down. Release
spring loaded knob where needed & tighten wing bolt. (See figures)
6