Advertisement
TURBO, EXTRO, SUPER, BRAVO, DURO & ECO STRIPPER
SUGGESTED BLADE SELECTION
BRAVO/DURO/ECO STRIPPER
#10-4906 8"Rigid. Our standard blade for removal of vinyl, carpet, adhesive, etc. Bevel edge of blade should
be up for concrete and down for wood sub-surfaces. Precutting of carpet and vinyl needed.
#10-4904 8"Flexible. Same as above, yet for uneven concrete surfaces and some soft foam back
carpet.
#10-4907T 8"Tile Blade. For use on VAT and VCT tile. Prevents tile from jamming in between blade and
blade holder. A must for tile removal to protect blade holder.
#10-4909 8"Razor Blade Attachment. An adapter to secure razor blades for removal of adhesives, paints and
thin films. Inexpensive and an excellent choice for complete clean up after floor covering removal.
#10-4903 8"X 5"Rigid. Ideal for hard to reach areas such as toe kicks, under radiators, etc. Also used for
clean up of small areas of parquet, ceramic, etc.
#10-4906D 8"X 2.5"Rigid Self Dicing. For use on carpet, rubber or vinyl. A real time saver, on pre-cutting
necessary since blade will cut strips with knife edged sides.
TURBO/EXTRO/SUPER STRIPPER
*Super Stripper uses 12" Blades Only
#10-4801D 14"Self-Dicing Blade. For use on carpet, rubber or vinyl. A real time saver, on pre-cutting
necessary since blade will cut strips with knife edged sides.
#10-4651T 12"Tile Blade. For use on VAT and VCT tile. Prevents tile from jamming in between blade and
blade holder. A must for tile removal to protect blade holder.
#10-4807 14"X 5"Ceramic/Parquet Blade. Ideal for removal for ceramic tile, marble, parquet,
and other wood floors. Precutting needed for plank floors.
#10-4809 Special Ceramic/Parquet Blade. This ¼" thick heavy duty blade is designed especially for the
ceramic tile and hardwood/parquet removal applications. The 14" wide blade extends out nearly 4" and is
designed at a specific angle to work more efficiently in cutting and lifting of thick materials. Best suited for the
long run, constant use in tile/wood applications for extended life and performance.
#10-4802 14"Rigid, #10-4652 12"Rigid. The standard blade for carpet, vinyl or adhesive removal, pre-
cutting of the floor is needed.
#10-4804 6"Rigid, #10-4803 8"Rigid. Use these blades for difficult removal like, epoxy, rubber floors,
sport surfaces, etc. Always position these blades to far left hand side of machine.
NOTE: All jobs can vary in difficulty of removal. Whatever blade you are using it may be necessary to take a
smaller bite in removal so it is less stressful on the operator as well as the machine. If you have any questions
on blade selection or choice of machine, please do not hesitate to call Sinclair Equipment Company or your
nearest distributor.
18
Advertisement
