Advertisement
Changing the blade
Disconnect the power supply and put on the
blade protection before changing the blade.
Use work gloves for your own safety.
- release bar on side of handle & tip the
machine as shown
-
put on the blade protection
-
(enclosed in the tool set)
Warning! Very sharp blade!
You may cause injury without using the blade protection!
- clean and loosen screws of the blade mounting
Attention! Set the wrench at a position opposite to the blade to avoid injury.
- replace the blade
Make sure that the blade fits in exactly into
the support. On normal and hard sub floors the
bevel of the blade should show upwards (1), on
soft sub floors the bevel should show downwards (2).
Changing the driving wheels
Remove the lynch-pins and pull the wheels from
the axle. Do not loose the wheel key under any
circumstances!
5.0 Use
The Turbo£ Stripper removes any bonded floor
coverings in strips. This procedure corresponds
with the customary method of using a hand floor
scraper. The stripper works with a steel blade at very high frequency, minimizing vibration
and noise.
The Turbo£ Stripper is self-propelled. The motor actuates both the blade and the
machine movement. The blade drive starts as soon as the machine is switched on
The hand clutch will engage the drive.
Starting
8
Advertisement
